Karcher KM 85/50 W B - Manual (Page 6)

Operating instructions KM 85/50 W B English
23
Sequence from the inside to the
outside
Insert hexagon head screw (A)
with washer (B) from the inside
through push handle (1)
Slip washer (B) onto hexagon
head screw
Push hexagon head screw (A)
through bottom part of push
handle (10)
Slip washer (B) onto hexagon
head screw
Push both sides of cover
support (11) onto hexagon head
screws
Slip one washer (B) on each of
the two hexagon head screws
Screw one nut (C) on each of the
two hexagon head screws and
tighten nuts so that the joint is
still flexible
Bowden cable assembly
Laying the bowden pull cable
Hinge adjusting nut (1) in
retaining plate (4)
Tighten locking nut (6), flat
washers (3 and 5), onto locking
nut (2)
Take out pin from fork head (7)
Position fork head (7) to lever (8)
Push pin through fork head (7)
and lever (8) and secure it
Side broom installation
Warning!
Close fuel shut-off valve prior to
starting assembly work.
Close the fuel feed line
—
Rotary knob is transverse to fuel
hose
Unlock push handle lock by
turning it anticlockwise
Danger!
—
The permissible maximum tank
filling when the sweeper is tilted
back onto the push handle is half!
Remove the debris container
prior to tilting the sweeper (see
section on "Emptying debris
container") and unlock the push
handle lock!
Tilt the machine back
Push side brush onto shaft
Fasten with screws (3 pieces)
Tilt the machine back upright
Before every operation
General notes
Stand sweeper on a flat surface
Shut-off the engine
Set parking brakes on the front of
the swivel caster
Turn push handle lock clockwise
—
The lock is interlocked
Testing and maintenance
work
Check the engine oil level. *
Check fuel level in tank.
Check the side brush.
Check the sweep roller. *
Clean filter. **
Empty the swept material
container. **
* See chapter on maintenance work
** See chapter on shutting off the
machine
Commissioning
Note:
—
Initial operation permissible only
if the unit‘s cover is closed!
—
For the protection of the operator,
the unit is provided with a safety
switch. The engine only runs
when the unit cover is closed.
Start machine
Open unit cover
Open fuel supply
—
Rotary knob is horizontal to fuel
hose
Close unit cover
Release parking brake