Temporary delete – Kenwood TK-3200 User Manual
Page 22
14
To start scanning, press the Scan key.
•
The LED indicator flashes green and scanning starts from the
current channel and ascends through the channel numbers.
•
When a signal is detected on a channel and the QT/ DQT
matches, scan pauses at that channel and the LED indicator
lights green.
•
When the signal is no longer present, scanning continues after 3
seconds (default).
To end Scan, press the Scan key again.
■ Temporary Delete
You can temporarily remove specific channels from the
scanning sequence during Scan. When Scan pauses at a
channel, you can remove that channel from the scanning
sequence by pressing and holding the Scan key for
1 second.
•
You cannot remove a channel if there will be less than
2 channels available for scanning remaining.
•
To add the removed channels back into the Scan list, simply
exit Scan mode or switch the transceiver power OFF and then
ON again.