Kenwood DDX7025 - Manual (Page 6)

English
6 English
Connection
The pin arrangement for the ISO connectors depends on the type of vehicle you drive. Make sure to make the proper connections to prevent
damage to the unit.
The default connection for the wiring harness is described in
1 below. If the ISO connector pins are set as described in 2 or 3 , make the
connection as illustrated.
Please be sure to reconnect the cable as shown
2
below to install this unit to the Volkswagen vehicles etc.
1 (Default setting) The A-7 pin (red) of the vehicle's ISO connector is linked with the ignition, and the A-4 pin (yellow) is
connected to the constant power supply.
2 The A-7 pin (red) of the vehicle's ISO connector is connected to the constant power supply, and the A-4 pin (yellow)
is linked to the ignition.
3 The A-4 pin (yellow) of the vehicle's ISO connector is not connected to anything, while the A-7 pin (red) is connected
to the constant power supply (or both the A-7 (red) and A-4 (yellow) pins are connected to the constant power
supply).
2CAUTION
Connecting the ISO Connector
Pin Numbers for ISO Connectors Cable Colour Functions
External Power Connector
A–4
Yellow Battery
A–5 Blue/White Power Control
A–7 Red Ignition (ACC)
A–8 Black Earth (Ground) Connection
Speaker Connector
B–1
Purple Rear Right (+)
B–2 Purple/Black Rear Right (–)
B–3 Gray Front Right (+)
B–4 Gray/Black Front Right (–)
B–5 White Front Left (+)
B–6 White/Black Front Left (–)
B–7 Green Rear Left (+)
B–8 Green/Black Rear Left (–)
Connector Function Guide
Unit Vehicle
Ignition wire (Red)
Battery wire (Yellow)
A–7 Pin (Red)
A–4 Pin (Yellow)
Unit Vehicle
Ignition wire (Red)
Battery wire (Yellow)
A–7 Pin (Red)
A–4 Pin (Yellow)
A–7 Pin (Red)
Unit Vehicle
Ignition wire (Red)
Battery wire (Yellow)
Connect to a power source
that can be turned on and off
with the ignition key.