Kenwood KDC-PSW9531 - Manual (Page 13)

English | 13
DTA Front/DTA Rear
DTA Subwoofer 0 — 610 (cm)
Position Setting Front-Left/ Front-Right/
Front/ ALL
• When the "2ZONE" of (page 11) is
"ON", the following setups are ignored.
- "X'Over"
- "DTA"
- "POSI"
- "Preset"
6 Exit Sound Field Control mode
Turn the [VOL] knob to select "Return".
Press the [VOL] knob.
Sound Management system
1 Select the source to adjust
Press the [SRC] button.
2 Show the Multi-function display
Press the [NEXT] button repeatedly until
"S.M.S" appears.
Refer to (page
9).
3 Enter Sound Management mode
Turn the [VOL] knob to select "S.M.S".
Press the [VOL] knob.
• When "2ZONE" of (page 11) is ON, you
cannot select "S.M.S".
4 Select the Sound Management item to
adjust
Turn the [VOL] knob to select the item you
want to select.
Press the [VOL] knob.
Multi-function item Sound Management Item
"Cabin" Cabin Setting
"Front" Speaker Select Front
"Rear" Speaker Select Rear
"Sub-W" Speaker Select Subwoofer
"Preset" Preset value storage/recalling
• "Preset": You can store an adjusted sound control
value by selecting "Memory". Refer to
(page 16). Also, you
can recall it by selecting "Recall". Refer to
(page 16).
5 Adjust the Sound Management item
Push the Control knob towards [ 4] or
[ ¢].
Each time you push the knob, the setting
alternates between the settings shown in the
table below.
Sound Managemnt Item Range
Cabin Setting OFF/ Compact/ Sedan/ Wagon1/
Wagon2/ Minivan1/ Minivan2/
SUV/ Passenger Van
Speaker Select Front 16cm/ 17cm/ 18cm/ 4x6/ 5x7/ 6x8/
6x9/ 7x10/ O.E.M./ 10cm/ 13cm
Speaker Select Rear 16cm/ 17cm/ 18cm/ 4x6/ 5x7/ 6x8/
6x9/ 7x10/ None/ O.E.M./ 10cm/ 13cm
Speaker Select Subwoofer 25cm/ 30cm/ 38cm over/ None/
16cm/ 20cm
6 Exit Sound Managemnt mode
Turn the [VOL] knob to select "Return".
Press the [VOL] knob.