Kawasaki 840015 User Manual

Page 9

SPECIFICATIONS

Voltage

120V

60 Hz

Rated Power

Low Heat (Position 1): 1000w
High Heat (Position 11): 1500w

Blowing Speed

Low Heat (Position I): >400L/min
High Heat(Position II): >550L/min

Air Temperature

Low Heat (Position I): 700°F (375°C)
High Heat (Position II): 920°F (495°C)

OTHER CONSUMER DO-IT-YOURSELF (DIY) TOOLS

Alltrade offers a full range of Kawasaki™ tools that make DIY jobs easy. If you would
like further information on the following products, please contact Alltrade Customer
Service Department at 1-800-590-3723.

Cordless Drills/Screwdrivers

Impact Wrenches

Sanders

Jigsaws

Circular Saws

Angle Grinders

Reciprocating Saws

Routers

Rotary Tools

Corded and Cordless Multi-Purpose Tools

Wide Range of Accessories and more

MAINTENANCE AND CLEANING

CLEANING: To avoid accidents, be sure to disconnect the

tool from the electrical power source before any cleaning or maintenance.

Avoid using certain cleaning agents and solvents.

Chemicals like gasoline, carbon tetrachloride, acetone, paint thinner or ammo-
nia products can damage the plastic parts of the tool. Use a soft dry brush to
keep the intake openings free of debris. Do not immerse the tool in liquid or
allow any liquid to get inside the outer casing.

STORAGE

Make sure the nozzle of the heat gun has cooled to room temperature before stor-
age. After many uses, the nozzle will become darkened by the heat, but this will not
interfere with the performance of the tool.

ACCESSORIES

Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may become hazardous when used on
another tool.

Always attach grounded (3-prong) extension cords to grounded (3-hole) outlets.

If you must use an extension cord, be sure that the gauge is large enough to carry
the amount of current necessary for your power tool. If not, your tool may experi-
ence a loss of power, excessive voltage drop or overheating. The smaller the gauge
number, the heavier the cord (see table below).

RECOMMENDED SIZES OF EXTENSION CORDS 120 VOLT AC 60 HZ TOOLS

TOOL CURRENT RATING

CONDUCTOR SIZE IN A.W.G

AMPERE

10FT.

25FT.

50FT.

100FT.

3-6

6-8

8-10

10-12

12-16

16-20