Kenwood P-110 - Manual (Page 8)

8
P-110 (En)
What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the table below to see
if the problem can be corrected before seeking help from your dealer or service representative.
Remedy Cause Symptom
No sound from both left and right chan-
nels or one channel. ÷ Turntable audio cable are not connected
correctly.
÷ Check connections to amplifier.
Loud hum, no music. ÷ Poor connection of turntable audio
cables.
÷ Make solid connections to amplifier.
Howling drowns out music when volume
is increased. ÷ Speaker vibration picked up by turntable. ÷ Separate turntable from speakers.
Turntable platter does not turn. ÷ Poor AC plug contact.
÷ Turntable belt does not engage with the
motor pulley.
÷ Check connection. Make sure AC outlet
is active.
÷ Engage the turntable belt with the motor
pulley.
Poor tracking ÷ Excessive dust on record or stylus.
÷ Stylus tip wear.
÷ Remove dust from stylus or record.
÷ Replace the stylus. (Refer to “Replacing
the stylus” on page 7.)
Motor and turntable
Drive system ................................................. Belt-drive system
Motor ............................................................................ DC motor
Turntable platter .......................................... 18.5 cm diameter
Speeds ....................................... 2 speeds; 33-1/3 and 45 rpm.
Wow & flutter .................................................... 0.1 % (WRMS)
S/N (rumble) ........................................................ 65 dB (DIN B)
Tonearm
Type ................................... Static balanced straight tonearm
Effective arm length ............................................ 203 mm (8")
Cartridge
Type ................................................................................ MM type
Stylus ............................................ N-69 with 0.6 mill diamond
Frequency response ....................................... 20 Hz to 20 kHz
Output voltage .......................... 2.5 mV (1kHz, 3.54 cm/sec.)
Equalizer amplifier
Output voltage
(MM. AMP ON) .................. 250 mV (1kHz, 3.54 cm/sec.)
General
Power consumption ............................................................. 5 W
Dimensions ............................................ W:
280 mm (11")
H : 87 mm (3-7/16")
D : 325 mm (12-13/16")
Weight (net) ........................................................... 2.0 kg (4.4lb)
Sound is too low or distorted. ÷ The MM.AMP ON/OFF switch under the
turntable platter is not set correctly.
÷ Set the switch correctly referring to
“Connections”.
Note:
Do not use contact cleaner because it could cause a malfunction. Be specially careful against contact cleaners containing oil, for they
may deform the plastic components.
In case of difficulty
Note:
KENWOOD follows a policy of continuous advancements. For this reason specifications may be changed without notice.
For your records
Record the serial number, found on the back panel of the unit, in the
spaces designated on the warranty card, and in the space provided below.
Refer to the model and serial numbers whenever you call upon your dealer
for information or service on this product.
Model Serial Number
Specifications