Kodak C503 EN - Manual (Page 44)

38 www.kodak.com/go/support
Troubleshooting
Camera/computer communications
Ready light glows
steady red. ■ Transfer pictures to the computer ( page 12 ), delete pictures from the
camera ( page 10 ), switch image storage locations ( page 23 ), or insert
a card with available memory ( page 3 ).
■ Wait. Resume picture taking when the light turns green.
■ Change the image storage location to internal memory ( page 23 ), or
use a different card.
Ready light glows
steady green. ■ Camera is operating normally.
If... Try one or more of the following
The computer does
not communicate
with the camera. ■ Visit www.kodak.com/go/c533support or
www.kodak.com/go/c503support .
■ Turn on the camera ( page 2 ).
■ Install new batteries ( page 1 ) or charge rechargeable batteries.
■ See the Power Management section of the laptop user’s guide to
disable this feature.
■ Connect cable to camera and computer port ( page 12 ).
■ Install the software ( page 11 ).
■ Disconnect the USB cable. Close all open applications. Re-install the
software (
page 11 ).
■ Disconnect camera from the computer. Close all software applications,
reconnect camera.
Cannot transfer
pictures.
(The Add New
Hardware Wizard
cannot locate
drivers.) ■ Disconnect USB cable. (If using camera dock or printer dock,
disconnect cable and remove camera from dock). Close all open
applications. Re-install the software (
page 11 ).
■ Disconnect the USB cable. Close all open applications. Re-install the
software (
page 11 ).
If... Try one or more of the following