beautypg.com

Bcl), Ptt id – Kenwood UHF P25 Transceiver TK-5810 User Manual

Page 42

background image

36

b

uSy

c

hAnnel

l

ocKouT

(bcl)

If set up by your dealer, you will be unable to transmit on a conventional channel

if it is already in use. Under these circumstances, use a different channel or wait

until the channel becomes free.
However, if BCL Override has also been programmed, you can transmit overtop

of the current signal:
1 Press and hold the microphone PTT switch.

• If the channel is already in use, a warning tone will sound.

2 Release the microphone PTT switch, then press and hold the microphone PTT

switch again within half a second.

3 Speak into the transceiver as you would during a normal transmission.

o

uT

oF

r

Ange

On Trunking channels, if set up by your dealer, the transceiver will indicate when it

is out of range. When it can no longer communicate with any site, an out of range

tone sounds and “OUT OF RANGE” appears on the display.

S

iTe

T

runKing

On Trunking channels, if set up by your dealer, the transceiver will indicate a

network condition on the registered site. When the transceiver receives a network

disabled message, “SITE TRUNK” appears on the display.

c

onTrol

c

hAnnel

h

unT

On Trunking channels, the transceiver must search for a control channel. While

searching for a control channel, no signals can be received. The search begins

automatically when you change to a Trunking channel.

pTT id

PTT ID is a unique transceiver ID code which is sent each time the microphone

PTT switch is pressed.

Note: PTT ID can be made only in FM Operation.

If Beginning of Transmit is set, the ID signal is transmitted when you press the

microphone

PTT switch.

If End of Transmit is set, the ID signal is transmitted when you release the

microphone

PTT switch.

If both are set, the ID signal is transmitted when you press and release the

microphone

PTT switch.

This manual is related to the following products: