Kenwood UHF P25 Transceiver TK-5810 - Manual (Page 30)

24
TRUNKING CALLS
M
AKing A
T
elephone
c
All
■ Manual Dialing
1 Press the key programmed as Autodial.
• The last called unit appears on the display.
• Press the
PF 2 key to switch the display between the unit name and the list
number.
2 Press and hold the PF 2 key to enter Store & Send mode.
3 Enter the desired digits using the DTMF keypad.
• Alternatively, you can select a digit by rotating the CH control, and then set the
selected digits by pressing the GRP key. Repeat this process to enter the
entire number.
4 Press the PTT switch to make the call.
• Alternatively, you can press the PF 4 key to page the selected unit, rather than
making a call.
■ Selecting a Number from the List
1 Press the key programmed as Autodial.
• The last called unit appears on the display.
• Press the
PF 2 key to switch the display between the unit name and the list
number.
2 Rotate the CH control to select your desired list number.
3 Press the PTT switch to make the call.
• Alternatively, you can press the PF 4 key to page the selected unit, rather than
making a call.
r
eceiving A
T
elephone
c
All
1 When a call is received, a ringing tone will sound and “PHONE CALL” will
appear on the display.
2 Press and hold the PTT switch to speak, and release it to receive.
• Only one person can speak at a time.
M
AKing A
S
TATuS
c
All
1 Select your desired zone and channel.
2 Press the key programmed as Status to enter status mode.
3 Rotate the CH control to select the status ID you want to transmit.
4 Press the PTT switch or the PF 4 key to initiate the Status call.
• After the status call has been successfully received by the called unit, “COMPLETE”
appears on the display.