Kenwood DPF-R 3030 - Manual (Page 21)

21
Timer operations
Timer playback of CD can be started at any time using an
audio timer which is available in audio stores.
1
Turn the powers of the associated components
ON.
2
Preparation
Load a disc in the CD player. 9
Set the amplifier volume.
3
1
Play the disc.
Set the timer ON time.
4
Set the timer so that it supplies power at the
specified time.
Turn OFF the power output from the audio
timer.
5
÷ With some audio timer models, the power is automatically turned OFF
when the timer ON time is set. With such a model, skip step 5 below.
Notes Notes
1. Some amplifiers cannot be used with a timer. Before using a amplifier, check it.
2. When operating the unit other than CD player using an audio timer, be sure to remove the disc from the CD player.
÷ If the amplifier is not connected to the CD player through a system
control cord, select the "CD" input with the input selector.
Preparation
÷ Connect the power cords of the associated
components so that their power can be
turned ON through the audio timer.
(Also, be sure to read carefully the instruc-
tion manual of the timer.)
This unit
System control cord Audio cord
Amplifier or receiver
Audio timer
To wall AC outlet
Label side
÷ When the set time comes, the disc playback starts automatically.
÷ Do not touch the ON/STANDBY (POWER/ ) keys of the amplifier
and CD player.
2 Adjust the amplifier volume.
3
Stop the disc.