Krell Industries KCT - Manual (Page 30)

26 Krell Current Tunnel
Customizing the KCT Preamplifier
The KCT preamplifier’s easy-to-use menu options allow you to select and set preferred
operating options for balance, inputs, trims, Theater Throughput mode, display
brightness, mute, trigger setup and delay, tape output, AC mains, remote programming,
setup memory, and Krell Link. The instructions below follow the menu order on your
KCT.
IMPORTANT
You do not need to press enter to set a selection. The last selection chosen is the one
entered in the system.
If at any time you wish to exit the menu without changing the settings, select EXIT MENU
(the last menu option) and press the enter button or key.
Z1 AND Z2 BALANCE
This option allows you to add a fixed positive offset to the main zone and zone 2
balance. With this feature, you can set the balance that is unique to your system’s
configuration.
1. Press the menu button (15) or key (41) to access the main menu.
2. The front panel display (13) reads Z1 BALANCE (the default).
3. Press the enter button (16) or key (42). The front panel display shows ZONE 1
BALANCE and the current balance setting.
4. Use the level control knob (14) or level keys (44) to adjust the balance to the desired
setting from 0 to +6 dB, in .5 dB increments.
5. Press the enter button (16) or key (42) to return to the main menu or press the menu
button (15) or key (41) to exit the menu mode.
To adjust the fixed offset for zone 2:
1. Press the menu button (15) or key (41) to select the main menu
2. Use the level control knob (14) or level keys (44) to select Z2 BALANCE .
3. Repeat steps 4 and 5 above.
INPUT NAME MENU
This option allows you to assign names to all inputs, for easy identification.
1. Press the menu button (15) or key (41) to access the main menu.
2. Use the level control knob (14) or level keys (44) to select INPUT NAME MENU .
3. Press the enter button (16) or key (42). The front panel display (13) shows INPUT
NAMES and S-1 (the default).