Kawasaki POWER WHEELS P5066 - Manual (Page 12)

12 P5066a-0920
Seat
Drive Buttons
• Fit the tab at the front of the seat into the slot near the drive
buttons A .
• “Snap” the tab at the back of the seat into the slot near the
rear of the vehicle B .
A
B
14
• Insert two #8 x 2" screws into the upper holes in the brush
guard and tighten.
• Fit both hand grips on the ends of the handlebar.
Hint: If it is difficult to slide a hand grip onto the handlebar,
moisten the inside of the grip with water.
• Locate the opening under the drive buttons.
• Reach into the opening and pull the high speed connector out
through the opening.
• See page 18 for information on high speed operation.
17
Connector
Drive Buttons
Hand Grip
Hand Grip
BACK VIEW 15
16