Step 9 - install the receiver, Step 10 - install batteries in remote, Install the receiver – KVH Industries TracVision M3 User Manual

Page 11: Install batteries in remote

54-0274-01 Rev. A

Once all cables are connected,
install the receiver inside the
vessel.

1. If you wish to mount the

receiver, attach the two
mounting brackets to the
sides of the receiver using three
#2-56 screws. Simply screw these
fasteners into the receiver’s vent slots.

2. If you are using the mounting

brackets, secure the brackets to the
mounting surface using appropriate

⁄

" fasteners (not supplied).

3. Place the RF converter at least 3 feet

(1 meter) away from the receiver. If it
is too close to the receiver, the remote
control might not operate properly.
Also avoid placing the RF converter
behind a metal surface or in an area
surrounded by metal.

4. If desired, mount the RF converter

using the supplied Velcro fasteners.

Install the Receiver

Bracket

#2-56 x 1⁄4" Screws (x3)

1⁄4" Fasteners (x4)

(not supplied)

To avoid overheating,
do not block the
receiver’s vents.

1. Remove the battery compartment cover from

the back of the remote control.

2. Insert two AAA batteries (supplied in the kit).

Be sure to observe the correct polarity.

3. Replace the battery compartment cover.

AAA Batteries

RF Converter

Receiver Mounted

Plug into
Receiver
(see page 8)

Install Batteries in Remote