Kodak ESP 3260 - Manual (Page 10)

4 www.kodak.com/go/aiosupport
2
Configuring Your Printer
This chapter presumes that you have set up your printer and that you may or may
not have installed the printer software.
Configuring printer settings
Configuring basic
printer settings NOTE: When you first power on the printer, the printer automatically steps you
through the process of selecting the Language.
To set or change basic printer settings:
1. Press Home.
2. Press to select Printer Settings, then press OK.
3. Press to select one of the following settings:
• Date and Time*
– Press OK, then press to select Year, Month, Day, Hour, or Minute.
Press or to change the values; press OK when you are done.
• Time to Low Power
– Press to change the time to energy-saving low power (select from 1 to 4
hours in 0.5 hour increments). After the Time to Low Power, the printer
goes into a low-power mode.
• Tagged Images Printing (see Printing tagged pictures, page 14 )
– Press to select On or Off.
If you select On, when you are printing pictures, the printer LCD prompts
you to verify that you want to print pictures that were tagged (or marked)
using your camera. Different cameras use different terminology; KODAK
Digital Cameras use “marked” images; others use either tagged images or
DPOF.
• Language
– Press OK, press to select a language, then press OK.
• Reset All Settings (see Resetting factory defaults, page 34 )
NOTE: Resetting factory defaults does not change the date and time, language, or
country/region.
4. Press Back.
* You can also synchronize the printer's date and time to your computer from Home
Center Settings under Tools in Home Center Software.