Kompernass Victoria 270 E - Manual (Page 16)

16
10. Sewing
If you have placed the thread and
everything is set correctly, as described
in the previous chapters:
a) To place the material
ᕣ Raise the needle fully, by turning the
handwheel.
ᕦ Raise the sew foot using the foot
pedal.
• Place the material under the sew foot
and lower the sew foot again.
b) To start a seam
ᕧ With the left hand, firmly hold the two
ends of the threads laid out towards
the rear.
• Now press very carefully on the foot
switch – just enough to complete the
first 3 or 4 stitches. While doing this,
guide the material with the right
hand.
ᕨ When the first stitches have been
successfully completed, briefly press
and hold the the reverse lever ...
• and, in the same way, step on the
foot switch – until you have returned
to the starting point. When you now
want to continue with the seam from
that point, it is held firmly by several
overstitches.
c) To finish off a seam
Sew back and forth at the end of the
seam using the reverse lever, as at the
start of the seam. The end of the seam
is now also held firmly.
»
ᕧ
ᕨ
²
IB_Sewingmachine_content_UK.qxd 22.07.2004 12:21 Uhr Seite 16