Kompernass Victoria 270 E - Manual (Page 12)

12
e) Threading with 2 needles
If you have inserted the twin needle, as
described in Chapter 8:
• Pull out both roll pins and put on
two spools of thread.
Ẫ You can put a felt pad under the
spool of thread, to protect the
machine casing.
• Pass the two upper threads through,
just as you would for a single thread,
...
ᕤ until the threads are at the needle:
but in this case, thread the two ends
of the upper threads separately
through the two needle eyes.
• The lower thread is also passed
through and collected in the same
way as for the single thread.
8. Attaching accessories
ƽ
Warning!:
First pull the power plug out of the
power socket! This will prevent the
machine from being started unintention-
ally while you are working.
a) Changing needles
First raise the needle fully, by turning
the handwheel.
ᕥ Loosen the clamping screw and
take out the old needle.
ᕦ Insert the new needle, with the flat
end towards the rear. Insert it up to
the top
ᕥ and turn the clamping screw to lock
it in place.
¿
´
²
IB_Sewingmachine_content_UK.qxd 22.07.2004 12:21 Uhr Seite 12