Konica Minolta PagePro 4650EN - Manual (Page 235)

Dual In-Line Memory Module (DIMM) 221
3
Using a screwdriver, loosen the
seven screws. (Do not remove
them from the printer.)
4
Slide the panel slightly to the
right and lift it off the printer.
5
Insert the new DIMM straight
into the DIMM connector until
the latches snap into the locked
position.
Observe the keyed side of the
DIMM to align it with the connec-
tor. If you cannot snap the DIMM
into place, do not force it. Repo-
sition it, making sure that the
DIMM is seated completely in
the connector.
6
Reinstall the panel and tighten the seven screws.
7
Attach the rear cover.
8
Reconnect all interface cables.