KITCHENAID ARCHITECT KERS308X - Manual (Page 7)

7
Removing and replacing the glide oven racks
To remove:
Use thumbs to press both left and right spring-loaded
release levers in, (See Fig. 1) and pull both the rack
straight out slightly. Release thumb levers, and grab both
the upper and lower portions of the glide rack while pulling
the rack straight out until reaching the stop position. (See
Fig. 2). At the stop, lift up front of rack slightly and continue
to pull rack away from oven. (See Fig. 3). Be sure to hold
on both upper and lower rack portions when removing from
or handling rack outside of the the oven - these rack
portions move independently and are difficult to handle
unless held together.
To replace:
Grasping both upper and lower portions of glide rack, lift
and place the rack resting evenly between the oven cavity
walls. Tilt the front of the rack upward slightly and slide the
rack completely into position. Some force may be
necessary to make sure the oven rack has snapped
completely back into place.
DO NOT attempt to close the oven door until all the oven
racks are properly positioned inside the oven cavity. Be
sure the glide oven racks make contact with the vertical
rack sensor located at the left rear oven cavity wall.
Fig. 1
Fig. 2
Fig. 3