General operation – Kenwood KDC-W241 EN User Manual
Page 6
6
|
KDC-W3041/KDC-W312/KDC-W241/KDC-241
General Operation
Audio Control
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Control mode
Press the [VOL] knob.
3
Select the Audio item to adjust
Press the [VOL] knob.
Adjustment Item
Display
Range
Subwoofer level*
“SW L”
–15 — +15
System Q
“NATURAL”/
“ROCK”/“POPS”/
“EASY”/“TOP40”/
“JAZZ”/“USER”
Natural/Rock/Pops/Easy/Top
40/Jazz/User setting
Bass level
“BAS L”
–8 — +8
Middle level
“MID L”
–8 — +8
Treble level
“TRE L”
–8 — +8
Balance
“BAL”
Left 15 — Right 15
Fader
“FAD”
Rear 15 — Front 15
Exit Audio Control mode (Volume control mode)
*Function of KDC-W3041/W312.
⁄
• “USER”: This appears when Bass level, Middle level, and
Treble level are adjusted. When “USER” is selected,
these levels are recalled.
4
Adjust the Audio item
Turn the [VOL] knob.
5
Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob.
Audio Setup
Setting the Sound system.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [VOL] knob.
Adjustment Item Display
Range
Low Pass Filter*
“LPF”
80/120/160/Through Hz
Volume offset
“V-OFF”
–8 — ±0 (AUX: -8 — +8)
*Function of KDC-W3041/W312.
⁄
• Volume offset: Sets each source’s volume as a difference
from the basic volume.
4
Adjust the Audio setup item
Turn the [VOL] knob.
5
Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1
Enter Standby
Press the [SRC] button.
Select the “STANDBY” display.
2
Enter Speaker Setting mode
Press the [VOL] knob.
3
Select the Speaker type
Turn the [VOL] knob.
Speaker type
Display
OFF
“SP OFF”
For 5 & 4 in. speaker
“SP 5/4”
For 6 & 6x9 in. speaker
“SP 6*9/6”
For the OEM speaker
“SP OEM”
4
Exit Speaker Setting mode
Press the [VOL] knob.
Switching Display
Changing the information displayed.
1
Enter Switching Display mode
Press the center of the Control knob for at least
1 second.
“DISP SEL” is displayed.
2
Select the Display item
Press the right or left side of the Control knob.
In Tuner source
Information
Display
Program Service name or Frequency
“FREQ”/ “FREQ/PS”
Radio text, Program Service name or Frequency*
“R-TEXT”
Clock
“CLOCK”
* This is not displayed on the KDC-W241/KDC-241.