Kenwood KDC-1032 - Manual (Page 9)

English | 9
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1 Enter Standby
Press the [SRC] button.
Select the "STBY" display.
2 Enter Speaker Setting mode
Press the [VOL] knob.
3 Select the Speaker type
Turn the [VOL] knob.
Each time you turn the knob, the setting
alternates between the settings shown in the
table below.
Speaker type Display
OFF "SP-F"
For 5 & 4 in. speaker "SP-5"
For 6 & 6x9 in. speaker "SP-6"
For the OEM speaker "SP-O"
4 Exit Speaker Setting mode
Press the [VOL] knob.
Clock Display
Press the [CLK] button.
Each time you press the button, the clock display
turns ON and OFF.
Adjusting Clock
1 Enter Standby
Press the [SRC] button.
Select the "STBY" display.
2 Select the clock display
Press the [CLK] button.
3 Enter clock adjustment mode
Press the [CLK] button for at least 2 seconds.
The clock display blinks.
4 Adjust the hours
Push the Control knob towards [FM] or [AM].
Adjust the minutes
Push the Control knob towards [ 4] or
[ ¢].
5 Exit clock adjustment mode
Press the [CLK] button.