Kenwood KDC-MP6039 - Manual (Page 23)

P.CONT
ILLUMI
ANT.
CONT
MUTE
REMO.CONT
L R
AUX
English | 23
Connecting Wires to Terminals
Battery
Ground wire (Black) - (To car chassis)
FM/AM antenna input
Fuse (10A)
Wiring harness
(Accessory
1)
Ignition wire (Red)
Battery wire (Yellow)
ACC
Car fuse box
If no connections are made, do not let the wire come out from the tab.
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Ignition key switch
Car fuse box
(Main fuse)
To Kenwood disc changer/ External optional accessory
⁄
To connect these leads, refer to the relevant instruction manuals.
Motor antenna control wire (Blue)
TEL mute wire (Brown) Connect to the terminal that is grounded when either the telephone rings
or during conversation.
⁄
To connect the Kenwood navigation system, consult your navigation
manual.
Power control/Motor antenna control wire
(Blue/White)
Connect either to the power control terminal when using the optional
power amplifier, or to the antenna control terminal in the vehicle.
Dimmer control wire (Orange / White)
To car light control switch
Depending on what antenna you are using, connect either to the control
terminal of the motor antenna, or to the power terminal for the booster
amplifier of the film-type antenna.
To use the steering wheel
remote control feature, you
need to an exclusive remote
adapter (not supplied) matches
your car is required.
Steering remote control
(Light Blue/Yellow)
AUX input (Stereo)
Use the mini-plug which is stereo type and does not
have any resistance.
Front output
Sub Woofer output
Rear output
USB connector (1m)
(KDC-MP6539U)
To USB device
⁄
Do not remove the cap when
you do not use the USB cable.
The connector will cause the
unit to malfunction if it gets in
touch with any metallic part of
the vehicle.