Kenwood KRC-178RG - Manual (Page 21)

set the time manually if the automatic time adjustment function
is turned off. The factory default is automatic time adjustment.
Display and setting:
"SYNC ON" : Automatic time adjustment
"SYNC OFF" : Manual time adjustment
Adjusting Time Automatically:
Tune into an RDS station for 3 or 4 minutes.
The time adjusts automatically to the correct local time.
The time is not adjusted when the RDS station you are tuned to is
not transmitting a time signal. Choose another RDS station in
such a case.
NOTE
With automatic time adjustment, you can set the clock time
automatically according to time data sent from RDS stations
(after receiving RDS signals for several minutes). You can also
Automatic Time Adjustment
Adjust the time manually.
This adjustment is available only when the automatic time
adjustment is set to off.
Display and setting:
Select the display "CLK ADJ" during the selecting function in
the menu system.
Hold down either the 4 or ¢ button for two seconds or
more to enter the Manual time adjustment mode.
The time display will blink.
• Adjusting the hours
Press the FM button to advance the hours, or press the AM
button to make the hours go back.
• Adjusting the minutes
Press the ¢ button to advance the minutes, or press the
4 button to make the minutes go back.
3
2
1
NOTE
Manual Time Adjustment
This function produces a beep sound that accompanies button
operation. It can be switched on or off.
Display and setting:
"BEEP ON" : Beep setting is on.
"BEEP OFF" : Beep setting is off.
The beep sound is not output from the preout jacks.
NOTE
Touch Sensor Tone
— 21 —