Krown Manufacturing 200 - Manual (Page 10)

I
8
GETTING STARTED
TO SETUP YOUR KROWN 200
Place your Krown 200 near your telephone. The power unit is connected to a regular power outlet and
the Memory Printer is used with your telephone.
• Be sure that the ON/OFF switch on the TDD is OFF.
• Plug small end of adapter cord into small hole at back of TDD.
• Plug AC Adapter/Charger into an electrical wall-outlet.
• Keep both ends plugged in even when machine is not being used for a telephone call.
Plug one end of your modular into the telephone wall jack. Plug the other end into either jack on the
back of your TDD. The second jack can be used to connect your telephone set or signaling device to
the TDD.
THE LIGHTS AND SWITCHES
GETTING STARTED (CONT.)
Phone Light Shows sounds heard on the telephone line.
Power Light Show status of power. When the light shows:
STEADY = Power is ON
FLASHING = Low battery power
NO LIGHT = Power is OFF
Power Switch: This switch turns the power ON and OFF
Print Switch: This switch turns the printer ON and OFF.