beautypg.com

Troubleshooting, As and when required, Unit does not work – Karcher HD 10/25 S USA User Manual

Page 12: Unit does not come up to pres- sure

background image

Operating Instructions HD 10/25 S USA

English

12

As and when required

„

Emptying and cleaning the detergent tank

– Pull out the screw cap and hose for the

detergent tank.

– Place the unit on its rear.

– Empty and clean the detergent tank.

Troubleshooting

Danger!
Before any repair work is undertaken,

switch the unit off and pull out the power plug.
Have electrical components checked and re-
paired only by authorised Customer Service
personnel.
For faults which are not identified in this chap-
ter, or when in doubt or when expressly in-
structed to do so, consult authorised
Customer Service personnel.

Indicator light

The indicator light shows the operating status
(green) and faults (red).

To reset:

„

Switch off the unit switch.

„

Wait a moment.

„

Switch the unit back on again.

Operating status display

„

Constant green light:

– Unit is operational.

„

1 x flashing green:

– Operational readiness expired after

30 minutes.

– The unit switched off after 30 minutes of

permanent operation (safety feature in
the case of a burst high-pressure hose).

Fault display

„

1 x flashing red:

– High-pressure side leaking. Check high-

pressure hose, hose connections and
hand-held spray gun for leaks.

„

2 x flashing red:

– Motor too hot. Switch off the unit switch.

Leave unit to cool down. Switch the unit
back on again.

„

3 x flashing red:

– Fault in the power supply. Check the

mains connection. Check supply fuses.

„

4 x flashing red:

– Current consumption too high. Consult

Customer Service

Unit does not work

„

Availability time has run out. The indicator
light will flash green. Switch the unit off and
then on again.

„

Check connecting cable for damage.

„

Consult Customer Service if there is an
electrical fault.

Unit does not come up to pres-
sure

„

Set nozzle to "high pressure".

„

Clean/replace nozzle.

„

Clean the fine filter, replace if required.

„

Evacuate air from the cleaner (see Switch-
ing on the unit).

„

Check water inlet volume (see Technical
Specifications).

„

Check all supply lines to the pump for leaks
or obstructions.

„

Seek the help of Customer Service if nec-
essary.

!