Kenwood TK-380 - Manual (Page 19)

14
■ Placing a Telephone Call (Keypad Models Only)
1 Select the desired system and group using the
encoder and the System or Group keys.
2 Press and hold the PTT switch for approximately
1 second to ensure a connection.
• Confirm that there is a dial tone after you release the
PTT switch.
3 Press and hold the PTT switch, then dial using
the front panel keypad.
• After dialing, release the PTT switch and wait for a
response from the called party.
4 When the called party responds, press the PTT
switch and speak into the microphone. Release
the PTT switch to receive.
• Only one person can speak at a time.
5 To end the call, press and hold the PTT switch,
then press the # key or the key programmed as
Tel Disconnect.
■ Receiving a Telephone Call (Keypad Models Only)
1 Select the desired system and group using the
encoder and the System or Group keys. (If the
Scan function has been programmed, you can
switch it ON or OFF as desired.)
• A ringing tone will sound when a call is received.
2 Press and hold the PTT switch to speak, and
release it to receive.
• Only one person can speak at a time.
3 To end the call, press and hold the PTT switch,
then press the # key or the key programmed as
Tel Disconnect.