Kodak EasyShare C330 - Manual (Page 51)

Troubleshooting
www.kodak.com/go/support 45
Camera ready light status
Picture is too light ■ Reposition camera to reduce the amount of available light.
■ Turn flash off ( page 26 ).
■ Move so that the distance between you and the subject is within the
effective flash range (
page 9 ).
■ To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light glows green, press the Shutter
button completely down to take the picture.
■ Use Auto, Landscape, or Close-up to adjust the exposure
compensation.
Picture is not clear ■ To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light glows green, press the Shutter
button completely down to take the picture.
■ Clean the lens ( page 59 ).
■ Make sure camera is not in Close-up mode if you are more than
27.6 in. (70 cm) from your subject.
■ Place the camera on a flat, steady surface or use a tripod, especially
in high-zoom settings or in low light.
If... Try one or more of the following
Ready light does
not turn on and the
camera does not
work ■ Turn on the camera ( page 2 ).
■ Recharge the battery or install a new one ( page 1 ).
■ Mode dial was on when battery was reloaded. Turn Mode dial off, then
back on.
Ready light blinks
green ■ Picture is being processed and saved to the camera. Camera is
operating normally.
■ Camera is connected. Camera is operating normally.
Ready light blinks
red and camera
turns off ■ Recharge the battery or install a new one ( page 1 ).
If... Try one or more of the following