Keys Fitness A7e - Manual (Page 6)

Assembly
6
Figure 2
Step 2
A) Insert Left Handlebar into the opening at the top of the left side on the Main Frame. Secure to the Pivot
Arm using a Small Washer and a M8*45mm Hex Bolt.
B) Slide two of the Cover Plates over the holes for the Short Screws.
C) Attach the Small Cover and secure in place using two Short Screws.
B) Slide a Grommet down the Left Handlebar and snap it onto the Main Frame.
Note: Make sure the Grommet is facing down as shown.
D) Repeat A, B, and C to complete the right side.
Left Handlebar
* Short Screw *
Grommet
M8*45mm Hex Bolt
Small Washer
Small Cover
Main Frame
* Short screw will come installed in unit, it must be removed before this assembly step begins. See Figure 2*