Keys Fitness A7e - Manual (Page 13)

Console Instructions
13
Sleeping Mode:
The console will go into Sleeping Mode and shut off the display if there is no speed signal or key
pressed for 3 minutes.
Sleeping Mode will end if any key is press or pedaling begins.
Console Service Mode:
Display Scroll Testing will show on the PROFILE WINDOW and "0"…"9", "A"…"F" on the
DATA WINDOW, press any key to pass the testing.
Keypad Testing will show the key button test results in the PROFILE WINDOW.
Press and hold STOP / RESET key for 2 seconds to pass all the testing.
Metric Unit Setting Mode:
Press and hold TIME UP and TIME DOWN for 2 seconds to set the mode.
Press LEVEL UP or LEVEL DOWN to select the mode you want..
Press START/ENTER to save the setting.
Press and hold STOP/RESET for 2 seconds to return to idle mode.
Error Message:
The TIME window will show an "Err1" message whenever the brake motor was unable to move
to its target position within 2 seconds of powering on. If this happens the console will immedi-
ately disable any further key operations until the motor error disappears.
Turn the console power off and then on again to see the error message will disappear. If the error
message remains call Keys Fitness Technical Service for more information.