Kenwood DIGITAL MEDIA RECEIVER KIV-BT900 - Manual (Page 59)

English |
59
Cancelling Category and Channel Search mode
Press the [MENU] button for at least 1 second,
and then press it again briefly.
⁄
• You cannot Channel search until the category
information is acquired.
Preset Memory
Putting the channel in the memory.
1
Select the channel you wish to store in the
preset memory
2
Enter Menu List mode
Press the [MENU] button.
3
Enter Preset Memory mode
Turn the [Volume] knob and press it when the
desired item is displayed.
Select “List & Memory”.
4
Select the number to put in the memory
Turn the [Volume] knob and press it for at least
2 seconds when the desired item is displayed.
Select the preset number.
⁄
• Only the channel number is stored. Category information
is not stored.
Preset Tuning
Recalling the channels in the memory.
1
Select Satellite Radio source
2
Enter Menu List mode
Press the [MENU] button.
3
Select a desired station in the memory
Turn the [Volume] knob and press it when the
desired item is displayed.
Select “List & Memory”
> Preset number.
Channel Scan
Every receivable Channel is checked for 10 seconds.
1
Select Satellite Radio source
2
Enter Menu List mode
Press the [MENU] button.
3
Start Channel Scan
Turn the [Volume] knob and press it when the
desired item is displayed.
Select “Channel Scan”.
4
Release it when the channel you want to listen
to is received
Press the [Volume] knob.
Function of remote control
Direct Access Tuning
Entering the channel and tuning.
1
Select Satellite Radio source
2
Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote
control.
3
Enter the channel
Press the number buttons.
4
Tune in to the entered channel
Press the [
4] or [¢] button.
Cancelling Direct Access Tuning
Press the [DIRECT] button on the remote
control.
⁄
• If you make no button operation for 10 seconds, the
Direct Access Tuning mode is automatically canceled.
• If you cannot receive any signal in the input Channel due
to bad conditions on radio wave or other such problems,
“Acquiring Signal”/ “No Signal” appears.