Kenwood KDC-U3046 - Manual (Page 20)

20 | KDC-U446/ KDC-U346/ KDC-U5046/ KDC-U4046/ KDC-U3046
Connecting Wires to Terminals
P.CONT
ANT.
CONT
MUTE
REMOTE
CONT
STEERING
WHEEL
REMOTE
INPUT
L R
Battery
Ground wire (Black) - (To car chassis)
FM/AM antenna input
Fuse (10A)
Wiring harness
(Accessory
1)
Ignition wire (Red)
Battery wire (Yellow)
ACC
Car fuse box
If no connections are made, do not let the wire come out from the tab.
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Ignition key switch
Car fuse box
(Main fuse)
Mute control wire (Brown)
Connect to the terminal that is grounded when either the telephone rings
or during conversation.
⁄ To connect the Kenwood navigation system, consult your navigation
manual.
Power control (Blue/White)
Front output
(KDC-U446/KDC-U5046 only)
Rear output/ Sub Woofer output
Motor antenna control wire (Blue)
Front side
AUX input (Stereo)
Use the mini-plug cable which is stereo type and
does not have any resistance.
USB connector
CA-U1EX
(Optional accessory)
Steering remote control
(Light Blue/Yellow)
To use the steering wheel remote control feature, you need to an
exclusive remote adapter (not supplied) matches your car is required.
(KDC-U446/KDC-U346/KDC-U5046/KDC-U4046 only)
When using the optional power amplifier, connect to its power control
terminal.
Depending on what antenna you are using, connect either to the control
terminal of the motor antenna, or to the power terminal for the booster
amplifier of the film or short pole-type antenna.
B64-4531-00_00_en.indd 20 09.10.2 2:35:10 PM