Kenwood KDC-MP235 - Manual (Page 8)

8 | English
General features
Audio Control
1 Select the source to adjust
Press the [SRC] button.
2 Enter Audio Control mode
Press the [VOL] knob.
3 Select the Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4 Adjust the Audio item
Turn the [VOL] knob.
Adjustment Item Display Range
Subwoofer level * "SW L" –15 — +15
System Q "NATURAL"/"ROCK"/
"POPS"/"EASY"/
"TOP40"/"JAZZ" Natural/Rock/Pops/Easy/
Top 40/Jazz
Bass level "BAS L" –8 — +8
Middle level "MID L" –8 — +8
Treble level "TRE L" –8 — +8
Balance "BAL" Left 15 — Right 15
Fader "FAD" Rear 15 — Front 15
Exit Audio Control mode (Volume control mode)
⁄
About System Q
• You can recall the best sound setting preset for different
types of music.
• Change each setting value with the
(page 8). First, select the speaker type with the Speaker
setting.
• "USER": This appears when Bass level, Middle level,
and Treble level are adjusted. When "USER" is
selected, these levels are recalled.
• *Function of KDC-MP2035/KDC-MP235/KDC-MP205
5 Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob and [ATT]
button.
Audio Setup
Setting the Sound system, such as Volume offset.
1 Select the source to adjust
Press the [SRC] button.
2 Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3 Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4 Adjust the Audio setup item
Turn the [VOL] knob.
Adjustment Item Display Range
Low Pass Filter* "LPF" 80/120/160/Through Hz
Volume offset "V-OFF" –8 — ±0 (AUX : –8 — +8)
⁄
• Volume offset: Sets each source’s volume as a difference
from the basic volume.
• *Function of KDC-MP2035/KDC-MP235/KDC-MP205
5 Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.
Bass Boost
Bass sound can be enhanced by one-touch
operation.
Press the [B.BOOST] button.
When you press the button once, the current Bass
Boost setting is displayed.
Each time you press the button, the Bass Boost
setting alternates.
Setting Display
Bass Boost 1 "BB-L L1"
Bass Boost 2 "BB-L L2"
Bass Boost off "BB-L OFF"
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1 Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2 Enter Speaker Setting mode
Press the [VOL] knob.