Kenwood KRF-V8030D - Manual (Page 9)

9
Remote Control
6 Press the key of the same operation that you want to store.
• The remote code is send to the remote control unit.
• "Complete" appears when finished.
• When it takes for more than 8 seconds or the remote control unit does
not receive the remote control code well, "Error" appears in the
display. In this case, re-operate from the step
1.
• "Full" appears when the memory is full. Re-operate from the step
1 after deleting some memories.
7 The remote control code is stored on the memory (Extend1 –
Extend5) of the remote control unit.
To operate other components by using the stored memory
2 Press the [Menu] key .
• The Menu display appears.
3 Press the 5 / ∞ keys to select the memory you want to operate.
4 Press the [Enter] key.
To delete the stored memory
Press the [Clr] key in step 5 . " Cleared " appears in the display
and the memory that is selected in step 4 is erased.
1 Press the MUSIC, MOVIE, or TV key to select desired input
source.
You can restore the setup codes or memories to their original default
settings.
• "Cleared" appears in the display, and the remote settings return to
their original default settings.
Getting the most from your remote control
5
+
–
+
– TUNING
BAND
ENTER
Insert the batteries during pressing and holding the [ 5]
keys and [ ] key.
2
1
Restoring the original factory settings
4 Press the 5 / ∞ keys to select the location.
• Extend1 – Extend5 are available.
5 Press the [Enter] key.
• The remote control is ready for receiving the remote control code.
>Extend1
Waiting
Clr Exit
> Extend1
> Extend1
Complete
Extend 1