Kenwood KDC-122S - Manual (Page 22)

English
— 22 —
Troubleshooting Guide
E-0d: The protective circuit in the unit activates when the
temperature inside the automatic disc changer
exceeds 60°C (140°F), stopping all operation.
E0d
➪ Cool down the unit by opening the windows or
turning on the air conditioner. As the temperature
falls below 60°C (140°F), the disc will start playing
again.
LOAd: Discs are being exchanged in the Disc changer. E57
IN (Blink): The CD player section is not operating properly. E59
➪ Reinsert the CD. If the CD cannot be ejected or the
display continues to flash even when the CD has
been properly reinserted, please switch off the
power and consult your nearest service center.
The messages shown below display your systems
condition.
E-01: No disc magazine has been loaded in the changer.
The disc magazine is not completely loaded.
E01
➪ Load the disc magazine properly.
No CD in the unit.
➪ Insert the CD.
E-02: No disc has been loaded in the disc magazine. E02
➪ Load a disc into the disc magazine.
E-04: No disc has been loaded in the disc magazine. E04
➪ Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-down. The CD
is scratched a lot.
➪ Clean the CD and load it correctly.
E-10: Nothing has been recorded on the MD. E10
E-11: No tracks are recorded on the MD, although it has a
title.
E11
E-12: The faceplate of the slave unit being connected to
this unit has been removed.
E30
➪ Replace it.
E-77: The unit is malfunctioning for some reason. E77
➪ Press the reset button on the unit. If the "E-77"
code does not disappear, consult your nearest
service center.
E-99: The unit is malfunctioning for some reason. E99A
➪ Press the reset button on the unit. If the "E-99"
code does not disappear, consult your nearest
service center.
KDC-2022/122_U.S 02.9.26 3:20 PM Page 22