Keys Fitness HealthTrainer HT-760T - Manual (Page 8)

8
Assembly
6. Connect the console harness together.
One side of harness is coming from the
right upright. The other end is coming
from the console.
Attach the console onto the uprights by
sliding into the uprights.
Secure the console to the uprights using
two bolts M10x25 and two washers M10
per side.
IMPORTANT PLEASE NOTE:
Tighten all hardware installed in Step 2
through Step 6.
Figure 6: Securing Console Assembly to Uprights
Bolt M10x25
Washer M10
Console
Console
Harness
5. Feed the console wire coming out of the
console through the tube of the right han-
dlebar. Connect the EKG harness and the
toggle harness coming from the handlebar
to the EKG harness and the toggle harness
coming from the console.
Secure the left and right handlebars to con-
sole using two bolts M8x50 and two wash-
ers M8 per side.
Figure 5: Console Assembly
Bolt M8x50
Washer M8
Console Harness
Left Handlebar
Right Handlebar
NOTE: Make sure that the console har-
ness is inside of the upright and not being
pinched.
NOTE: Make sure not to pinch any wires
when securing the left handlebar.
EKG
Harness
EKG
Harness
Toggle
Harness
Toggle
Harness