beautypg.com

Warning, Electrical requirements, Undercounter installation – Kenmore 665.1363 User Manual

Page 6

background image

6

Cutout dimensions

Clearance dimensions

Electrical Requirements

Recommended Grounding Method

This compactor is for use on a single phase, 115-volt, 60 Hz, AC
only 15- or 20-amp fused and properly grounded circuit and is
equipped with a grounding plug as shown below. It is
recommended that a separate circuit serving only this appliance
be provided.

This compactor must be grounded while in use to reduce the risk
of electric shock. The compactor is equipped with a three-
conductor cord and 3 prong grounding-type plug to fit the proper
grounding-type receptacle. The green (or green and yellow)
conductor in the cord is the grounding wire. Do not connect the
green (or green and yellow) wire to a live terminal.

Undercounter Installation

NOTE: Proper installation is your responsibility. Make sure you
have everything necessary for correct installation. It is the
personal responsibility and obligation of the customer to contact
a qualified installer to assure that electrical installation meets all
national and local codes and ordinances.

Tools needed

Gather the required tools and parts before starting installation.

IMPORTANT:

Slide compactor onto cardboard or hardboard before moving
compactor across floor to avoid floor covering damage.

Do not allow the rear frame of the compactor to touch the
floor covering when lifting or moving compactor.

A. Grounded electrical outlet must be a minimum of 3" (7.6 cm) away

from surrounding cabinets or nearby walls as shown. It can be
placed either to the left or the right side of the product.

A. Leave 6" (15.2 cm) of clearance space to the right side of the

compactor in order to remove the compactor bags.

B. Leave 23" (58.4 cm) of clearance in front of the compactor in order

to fully open or remove the compactor drawer.

A

24" min.

(61 cm)

34

¹⁄₄

" min.

(87 cm)

18" min.

(45.7 cm)

3" min.

(7.6 cm)

15

¹⁄₄

" min.

(38.7 cm)

B

A

Level

Phillips No. 2 screwdriver

Tape measure

Flat-blade screwdriver

Pliers

⁵⁄₁₆" hex-head socket
wrench

Scissors

Utility knife

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Failure to follow these instructions can result in
death, fire, or electrical shock.

Do not use an extension cord.

Do not use an adapter.

Do not remove ground prong.