beautypg.com

Installation instructions, Warning, Unpacking – Kenmore 665.1363 User Manual

Page 5: Location requirements

background image

5

INSTALLATION INSTRUCTIONS

Installer: Leave Use and Care Guide with the homeowner.

Homeowner: Keep Use and Care Guide for future reference and
for local electrical inspector’s use, if required.

Unpacking

IMPORTANT: Begin in the room where the compactor will be
located.

1. Remove compactor from shipping carton. Remove all

protective packaging materials such as tape and shipping
pads. Use a mild detergent and warm water to remove waxy
residue caused by protective shipping material. Dry
thoroughly with a soft cloth. For more information, see
“Cleaning.”

2. Check to be sure the power cord is attached to the cord clip

on the rear of the compactor.

3. Place the 2 corner posts from the carton on the floor near the

compactor. Press the foot pedal to open the compactor
drawer and remove any shipping materials or other items
from the drawer. Do not remove the compactor bag. Grasp
sides of drawer and lift drawer out of compactor. Place the
drawer on the 2 corner posts.

4. Place the other 2 corner posts on the floor to the side of the

compactor. Grasp the sides of the compactor cabinet and put
compactor on its side on top of the corner posts. Remove the
shipping base from the bottom of the compactor.

Location Requirements

Product dimensions

A. Cord clip

WARNING

Excessive Weight Hazard

Use two or more people to move and install
compactor.

Failure to do so can result in back or other injury.

A

A. Leveling legs
B. Shipping base

B

A

34

¹⁄₈

"

(86.7 cm)

24"

(61 cm)

15"

(38.1 cm)