Kenwood KRC-791 - Manual (Page 40)

English
— 40 — — 40 —
The messages shown below display your systems
condition.
Eject: No disc magazine has been loaded in the changer.
The disc magazine is not completely loaded.
E01
➪ Load the disc magazine properly.
No CD in the unit.
➪ Insert the CD.
No Disc: No disc has been loaded in the disc magazine. E02
➪ Load a disc into the disc magazine.
TOC Error: No disc has been loaded in the disc magazine. E04
➪ Load a disc into the disc magazine.
The CD is quite dirty. The CD is upside-down. The CD
is scratched a lot.
➪ Clean the CD and load it correctly.
Blank DISC: Nothing has been recorded on the MD. E10
No Tr DISC: No tracks are recorded on the MD, although it has a
title.
E11
NO PANEL: The faceplate of the slave unit being connected to
this unit has been removed.
E30
➪ Replace it.
E-77: The unit is malfunctioning for some reason. E77
➪ Press the reset button on the unit. If the "E-77"
code does not disappear, consult your nearest
service center.
Mecha Error: Something is wrong with the disc magazine. Or the
unit is malfunctioning for some reason. E99
➪ Check the disc magazine. And then press the reset
button on the unit. If the "Mecha Error" code does
not disappear, consult your nearest service center.
Hold Error: The protective circuit in the unit activates when the
temperature inside the automatic disc changer
exceeds 60°C (140°F), stopping all operation.
E0d
➪ Cool down the unit by opening the windows or
turning on the air conditioner. As the temperature
falls below 60°C (140°F), the disc will start playing
again.
NO NAME: Attempted to display DNPS during the CD play having
no disc names preset.
E51
NO TITLE: Attempted to display the disc title or track title while
the MD having no MD title is being played.
E53
NO TEXT: • Attempted to display the disc text or track text
while the CD having no CD text is being played. E54
• Attempted to display text during reception of the
station that isn't sending text data. E55
Waiting: Radio text data is being received. E56
Load: Discs are being exchanged in the Disc changer. E57
NO ACCESS: After setting it in the Disc Changer, DNPP was done
without having it been played at least 1 time. E58
IN (Blink): The tape player section is not operating properly. E60
➪ Reinsert the Tape. If the tape cannot be ejected or
the display continues to flash even when the tape
has been properly reinserted, please switch off the
power and consult your nearest service center.
NOT.AVAILABLE Adjust the panel angle during tape play. E62
Troubleshooting Guide
KRC-791_U.S 01.10.29 11:54 AM Page 40