Kenwood KDC-C469FM - Manual (Page 15)

— 15 —
Installation Procedure
Angle adjustment switches ■
The angle adjustment switches on the both saides of the unit
are to be set according to the angle of installation of the CD
auto changer. Set both of the two switches to the same
position. If the switches are not set properly, sound skip or
other malfunction may occur.
Set the angle adjustment switches with a coin or other flat
object.
Change the switch step by step by detaching and reusing the
object at the end of each step.
Right side Left side
Angle adjustment switches
90 90
0 45
90
0 45
Installation
angle
0°~5° 40°~50° 85°~90°
90
0 45
90
0 45
90
0 45
Angle
adjustment
switch
position
• It is not possible to install at an angle of
40°~50° if only 1 is used.
Installation
Installation of Display unit ■
• Installation without using the trim mount plate 7
Attach one velcro to the
slanted-line of the the display
units as shown above, and
attach the other velcro to the
parts where you wish to
attach the display units.
Then, put velcros together
and install the display units.
• Installation using the trim mount plate 7
C D A U T O C H A N G E R C O N T R O L L E R REP
RDM
3
1 ¡ PWR
' R D M R E P M H z
T R A C K D I S C
8 /
T R A C K
FREQ LEVEL
- +
DISC
Display unit
Display unit
5
7
Pass the wire from the display unit through the hole on the
trim mount plate and push fit the display unit into the trim
mount plate until it locks.
• Be sure not to place the unit on such place as where it is
exposed to direct sunlight and temperature eventually rises.
It results in the deformation of the case.
• Depending on the installing location, the display unit may not
be able to receive the signals from the controller unit. Install
them after confirming that the signals can be received.
• Install the unit in such a way that it does not disturb driving.
2CAUTION
KDC-C519/469FM(K/E)/U.S 02.9.24 10:24 AM Page 15