Klipsch DVD Audio/Video System CS-700 - Manual (Page 6)

Disconnect the cable on your cable, satellite or HD set-top box that is
connected to your TV (you need to connect 1 video and 1 audio).
Connect the VIDEO—look at the options available on the set-top box
and choose 2A, 2B or 2C.
To maintain best picture quality—if the back of the set-top box
has HDMI or COMPONENT VIDEO (
Y, P B , P R ) OUTPUT jacks, plug
corresponding cable(s) into the jack(s) on the set-top box and to
the Klipsch system’s
SAT/CABLE/HD INPUT HDMI or COMPONENT
jacks (Y to Y; P B to P B , P R to P R ). If you use 2A or 2B, you must
also connect the corresponding output from the Klipsch controller’s
“VIDEO OUTPUT” section to your TV to ensure that you get a picture.
These cables have not been included with the Klipsch system.
When using the HDMI connections you must turn Progressive Scan
(
P. SCAN) “On”. If the HDMI connections are used and P. SCAN
is “Off”, you will not see a picture.
If the set-top box has a VIDEO (yellow)
OUTPUT jack for video, plug
the supplied yellow video cable into that jack and to the Klipsch
system’s
SAT/CABLE/HD INPUT COMPOSITE (yellow) jack.
1.
2.
CABLE IN
O U T P U T S
VIDEO S-VIDEO
COMPONENT
Y P
B
P
R
CABLE BOX (shown)
DIGITAL
COAXIAL OPTICAL
AUDIO
L R
CABLE SIGNAL
- OR -
- OR -
- OR -
2B
2C
3D 3C
3B
HDMI OUT
2A
KLIPSCH CONTROLLER
3A
OR
STeP 3A: Set-Top Box Connection
Connect the AUDIO—look at the options available on the set-top box
and choose 3A, 3B, 3C or 3D.
If an HDMI cable is used, audio is already connected through this cable.
Connect the supplied audio cables to the AUDIO LEFT (white) and
AUDIO RIGHT (red) jacks on the back of the set-top box and to the
Klipsch system’s
SAT/CABLE/HD INPUT LEFT (white) and RIGHT
(red) jacks.
If the set-top box has Digital AUDIO (
COAXIAL ), connect appropri-
ate cable to the set-top box AUDIO COAXIAL jack and to the
SAT/CABLE/HD INPUT COAXIAL jack.
If the set-top box has Digital AUDIO ( OPTICAL ), connect appropriate
cable (not supplied) to the Klipsch System’s SAT/CABLE/HD INPUT
OPTICAL jack. You will first need to remove the plastic dust plug.
Note: If you connect a high definition Y, P B , P R INPut, you must also
connect the corresponding Y, P B , P R outPut to your tV. If you connect a
HDMI, you must also connect the corresponding output from the Klipsch
controller’s “VIDeo outPut” section to your tV to ensure that you get a
picture. these cables have not been included with the Klipsch system.
3.
A.
B.
C.
D.
Use this connection if your TV has a cable box, satellite receiver or HD receiver set-top box connected to it.
See next page (3B) if no set-top box is used.
A. B.
C.
Please see appendix I (page 28) for the basics on how input
and output jacks work with your Klipsch system.
Input and Output Jacks