Kawasaki 691295 - Manual (Page 6)

B BIIT T IIN NS SE ER RT TIIO ON N
• Unplug the drill. Never change bits
on a live drill.
• Make sure the bit is undamaged,
sharp and free from wood or metal
shavings. Foreign material on the
bit may keep the chuck from tight-
ening fully. A loose bit may cause
injury.
• Push the bit into the chuck as far
as it will go.
• Make sure the bit is in the center
of the chuck. If the bit is off-cen-
ter, it will not be held securely and
may fly loose during use causing
serious injury.
• Insert the chuck key into one of the three chuck holes. Rotate the chuck key
clockwise to lock the bit in place.
• Remove the chuck key.
A Allw waayyss rru un n tth hee d drriillll ffo orr o on nee m miin nu uttee b beeffo orree d drriilllliin ng g tto o
m maakkee ssu urree tth hee b biitt iiss p prro op peerrllyy sseeaatteed d.. If the bit needs to be adjusted, unplug
the drill before touching the bit.
B BIIT T R RE EM MO OV VA AL L
• Unplug the drill.
• Insert the chuck key into one of
the three chuck holes. Rotate the
chuck key counterclockwise to
unlock the bit.
• Remove the bit.
9
O OP PE ER RA AT TIIN NG G T TH HE E O ON N//O OFFFF S SW WIIT TC CH H
Squeeze the trigger switch to turn the tool “ON”. Release the trigger switch to turn
the tool “OFF”.
When drilling for extended periods, the “Lock-On” switch may be used, but do not
use this switch in situations where the drill is likely to bind or kickback. If kickback
does occur, the sudden motion of the tool may make it difficult to release the “Lock-
On” switch and turn the drill off.
S SP PE EE ED D C CO ON NT TR RO OL L A AD DJJU US ST TIIN NG G S SW WIIT TC CH H
To increase the operating speed of the
drill, squeeze the trigger switch. To
decrease the speed, release the trigger
switch.
D DIIR RE EC CT TIIO ON N C CO ON NT TR RO OL L L LE EV VE ER R
The direction control lever changes the
rotation of the drill chuck. It is located just
above the trigger switch. ALWAYS turn the
motor off and let the bit come to a
complete stop before moving the switch.
Depress the “R” arrow switch on the left
side of the drill for a forward rotation of the
bit. Depress the direction switch lever on
the right of the drill for the bit to rotate in
reverse.
Do not change the direction of a moving bit. Make sure the
bit comes to a complete standstill before moving switch. Changing direction
while the bit is moving can cause damage to the drill.
10
LOCK-ON SWITCH