K & M - Konig & Meyer CMP-VOIP60 User Manual

Page 3

5.3 Call Hold/Retrieve
Operation: While on a call, press ‘HOLD’ button on the phone then the call will be on hold. You
can dial the new number. To retrieve the previous call just press it again.

5.4 Call Transfer
Attendant Transfer
Operation: While person B calls person A, press ‘FLASH’ button. Input the destination number of
a third person, C, and ‘#’. After person C picks up the call you can tell her/him there is a call for
him and hang up, then the call will be transferred to person C.

5.5 3-way calling
Operation: While person A and B are in a phone call, press ‘HOLD’ button, input the 3

party’s

number and ‘#’. After the third party picks up the call, you can press ‘CONF’ to begin a 3-way call.

5.6 Call waiting/Answer the waiting call
When on a call and a new call comes in, you will hear the waiting tones. Press the ‘HOLD’ key
on the phone to pick up the new call.

5.7 Display Missed Call
When there is a missed call on the server, the device will get a signal from server and you will
see the information ‘1 Missed Call’ on the screen.

5.8 Voice mail
When there is a voice mail on the server, the device will get a signal from server and you will see
the indicator of SPEAKER flashing.

5.9 Multiple lines
You can set 3 different accounts and server information on the device. When the device is idle,
pick 1*, 2*, 3* to select the 1

and 3

line, then hang up the handset or press ‘SPEAKER’

key, you will be speaking on the chosen line. 1

account is the default one after a reboot.

5.10 VoIP: Do not disturb
You can set in the web page: Phone setting->Block Settings. If you set it, all incoming calls will
not cause the device to ring, but leave the unreceived record on the LCD screen. You can set
this feature for a specific block of time. If the end time is earlier than the beginning time, it means
the DO NOT DISTURB duration will be from beginning time to next day’s end time.
The screen will show #DND#, and the phone now is in DO NOT DISTURB status. You can set in
the web page: Phone setting->Block Settings. If you switch it off, then the phone is idle and it will
change the phone to normal status.

6 How to use the stand
To change the stand angle, please follow the pictures:

Press
here

-5-

Safety precautions:
To reduce risk of electric shock, this product should ONLY be opened by an authorized
technician if service is required. Disconnect the product from mains and other equipment if a

problem should occur.

Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or
damage caused due to incorrect use of this product.

General:
Designs and specifications are subject to change without notice.