beautypg.com

Troubleshooting guide – Kenwood KDC-M4524G EN User Manual

Page 27

background image

— 27 —

What might seem to be a malfunction in your unit may
just be the result of slight misoperation or miswiring.
Before calling service, first check the following table
for possible problems.

General

?

The power does not turn ON.

01

✔ The fuse has blown.

☞ After checking for short circuits in the wires, replace the fuse with

one with the same rating.

?

There’s a source you can’t switch.

07

✔ There’s no media inserted.

☞ Set the media you want to listen to. If there’s no media in this

unit, you can't switch to each source.

✔ The Disc changer isn’t connected.

08

☞ Connect the Disc changer. If the Disc changer isn’t connected to

it's input terminal, You can't switch to an external disc source.

?

Even if Loudness is turned ON, high-pitched tone isn't compensated
for.

17

✔ Tuner source is selected.

☞ High-pitched tone isn't compensated for when in Tuner source.

?

No sound can be heard, or the volume is low.

✔ The fader or balance settings are set all the way to one side.

21

☞ Center the fader and balance settings.

✔ The values of Volume offset are low.

24

☞ Turn up the Volume offset, referring to the section on

control> (page10).

?

The sound quality is poor or distorted.

25

✔ One of the speaker wires is being pinched by a screw in the car.

☞ Check the speaker wiring.

✔ The speakers are not wired correctly.

27

☞ Reconnect the speaker wires so that each output terminal is

connected to a different speaker.

?

The Touch Sensor Tone doesn’t sound.

34

✔ The preout jack is being used.

☞ The Touch Sensor Tone can’t be output from the preout jack.

?

Even though Synchronize Clock is ON, the clock can’t be adjusted.

35

✔ The received RDS station isn’t sending time data.

☞ Receive another RDS station.

Tuner source

?

Radio reception is poor.

39

✔ The car antenna is not extended.

☞ Pull the antenna out all the way.

?

It isn't the set Traffic information sound volume.

43

✔ The set sound volume is less than the tuner sound volume.

☞ If the tuner sound volume is louder than the set sound volume,the

tuner sound volume is used.

Troubleshooting Guide

KDC-M4524G_U.S 03.7.8 9:23 AM Page 27