Station name preset (snps) – Kenwood KRC-708 User Manual

Page 15

— 15 —

Press the preset station button (#1-6) for the desired station.
The number of the recalled station is displayed.

• When the local seek function is turned while auto memory

entry takes place, stations with poor reception are not stored.

• When the Traffic Information function is on , only the local

traffic information station frequency will be stored.

NOTE

Continue steps 3 and 4 until all the characters are chosen for
the name.

You can enter up to 8 characters for each name.

Assigning Names
Press the NAME.S button.
The name of the station is stored in memory, and the Station
Name Preset mode ends.
Also, if you make no input for 10 seconds, the name will be
stored up to the point that you have entered, and the mode
ends.

• You can assign names to up to 32 FM stations and 16 AM

stations.

• All the station names will be erased if you press the RESET

button.

• If you want to change the name of a station, first display the

name of the station (following steps 1 and 2 above), then
change the letter(s) that you want by following steps 3 and 4.

NOTE

Alphabet (upper case): A ~ Z

Alphabet (lower case): a ~ z

Numerals and symbols: 0~9 @ ” ‘ ` % & * + - = , . / \ < > [ ]

Special characters: б а й и н м у т ъ щ С З ® Я ‹ ﬂ

в д к л о п ф ц ы ь с з © Ж › ﬁ

You can assign names to radio stations with the Station Preset
Memory. Up to 32 FM stations and 16 AM stations can be
assigned names.

Adjust the frequency to the station whose name you want to
enter.

The station name preset function cannot be used when a
program service name or radio text is displayed.

Press the NAME.S button for at least two seconds.
"NAME SET" is displayed once the station name preset mode
is entered.
The cursor will blink in the position where letters are entered.

Press either the

4 or ¢ button to move the cursor to the

desired position.
The

4 button moves the cursor to the left, and the ¢

button to the right.

Each time the

38 button is pressed, the characters to be

entered change as listed below.
Press the FM or AM button to display the desired character.
Characters that can be displayed are as follows.

NOTE

Station Name Preset (SNPS)

KRC-X858_U.S-4 00.12.27 0:12 PM Page 15