Kustom GROOVE 115C - Manual (Page 9)

9
GROOVE 115C
Specifications
Model Groove 115C Bass guitar amplifier
Input Impedance
Output Power 600 Watts 3 Ohms @ 5% THD
Hum & Noise -60db Residual Noise, all level controls 0% (minimum)
27db Preamp output
15db Preamp output, Active
25db Tuner output
27db Direct output
32db Power amp gain
Amplifier Type Class B Descrete device Class B amplifier
Speaker 1 X 15" Specially Designed Eminence Speaker
USA/Canada 120VAC/60Hz, 800W nominal
Europe 230VAC/50Hz, 800W nominal
UK 230VAC/50Hz, 800W nominal
Australia 240VAC/50Hz, 800W nominal
Japan 100VAC/50-60Hz, 800W nominal
mm/kg 798 (Height) x 483 (Width) x 508 (Depth), 48 kg
Inches/Pounds 31.5 (Height) x 19 (Width) x 20 (Depth), 106 lbs
Dimensions
Power Requirements
Footswitch
System Gain
All measurements taken with 1 KHz
input signal, Tone controls flat, Gain and
Volume Maximum. Measured at effects
send output jacks on rear unless noted.
200K Ohm
Use any standard tip-ring-sleeve cable
Any non-momentary two-button foot switch can be used.
Frequency Response 20HZ-20kHz
Actual response is tailored to speakers for accurate acoustical
response using a bass guitar as input.