Kenwood KDC-MP205 - Manual (Page 26)

26 | English
Connecting Wires to Terminals
MUTE
P.CONT
FRONT L
FRONT R
REAR L
REAR R
– +
FRONT
ANT.
CONT
Battery
Ground wire (Black) - (To car chassis)
FM/AM antenna input
Fuse (10A)
Wiring harness
(Accessory
1)
Ignition wire (Red)
Battery wire (Yellow)
ACC
Car fuse box
If no connections are made, do not let the wire come out from the tab.
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Ignition key switch
Car fuse box
(Main fuse)
Rear left output (White)/ Rear right output (Red)
(KDC-MP235CR only)
Front right output (Red)
(KDC-MP2035 only)
Front left output (White)
(KDC-MP2035 only)
To Kenwood disc changer/ External optional accessory
(KDC-MP2035/MP235 only)
⁄
To connect these leads,
refer to the relevant
instruction manuals.
Not Used (Blue)
TEL mute wire (Brown) Connect to the terminal that is grounded
when either the telephone rings or
during conversation.
⁄
To connect the Kenwood navigation system,
consult your navigation manual.
Power control/Motor antenna control wire
(Blue/White)
Connect either to the power control
terminal when using the optional power
amplifier, or to the antenna control
terminal in the vehicle.
⁄
Do not let the wire come out from
the tab.
Rear left output / Sub Woofer left output (White)
Rear right output / Sub Woofer right output (Red)
(KDC-MP2035/MP235/MP205 only)