Kicker SKM10 User Manual

Page 3

PERFORMANCE

INST

ALLA

TION

Note: The use of a subsonic filter will significantly increase the power handling.

The power handling specifications in these charts are calculated using a 25Hz, 24dB per octave subsonic filter.

Power Handling Watts RMS without subsonic filter: SKM10-125

Wiring

Remove the cover for the speaker terminal cup, plug your subwoofer speaker wire into the
terminals, using the red connector as positive and the black connector as negative. Connect
the other end of the wire to your subwoofer amplifier in accordance with its owner's manual.
Replace the cover for the speaker terminal cup, by snapping it into place. See Figure 7.

SKM10

300 (150)

8 5/16 (21.1)

16 1/16 (40.8)

23 15/16 (67.4)

Performance

Model:

Nominal Impedance [Zn], ohm [per enclosure]

Power Handling

Watts, Peak (RMS)

Enclosure Depth, in (cm)

Enclosure Height, in (cm)

Enclosure Width, in (cm)

SafetyWarning

To avoid potential injury, or possible death, from forward movement of the enclosure during
abrupt stops or accidents, the enclosure must be properly installed and securely fastened to
your vehicle. You are solely responsible for securely fastening the enclosure in your vehicle.

Figure 5

Figure 6

Subwoofer firing

into the wall

or floor

Mounting

Flange

exposed

Subwoofer firing

away from the

wall or floor

Mounting

Flange
tucked

under the
enclosure

Figure 7

Kicker Marine speakers use the highest level of magnetic shielding available to minimize compass and gauge deviation in your dash.

Kicker Marine speakers meet or exceed industry standards for environmental humidity and corrosion,

and for material degradation due to UV exposure.

KMCOAXIALSPEAKER

Speaker Terminal

Cup Cover