Extremely important – King Canada 9818-RJ User Manual
Page 10
ELECTRICAL HAZARD WARNING!
To verify proper operation of the components in their selected locations, perform a System
Location check as follows:
5. Connect system as outlined in Fig. 10, Page 13.
6. Verify system operates properly as described in Section 4 OPERATION, Page 18.
7. After verifying proper operation of the system, disconnect all components.
The coaxial cable that connects the dome unit to the tuner
carries a 24 volt electrical current. Exercise extreme
caution when handling this cable. Do not cut, break, or
splice this line. Do not insert or connect any devices such
as splitters or any other device for any reason. This line is
not compatible with any other equipment. Damage will
occur to any device other than the dome unit if connected
to the antenna port on the tuner.
Page 8
4. Place the dome unit on its mounting pedestal and temporarily secure the unit from falling.
DO NOT PERMANENTLY MOUNT THE DOME UNIT UNTIL YOU HAVE COMPLETED
THE SYSTEM LOCATION CHECK ON THIS PAGE.
If mounting to the vessel surface, you will need to temporarily place it on a pedestal to
perform the system location check.
EXTREMELY IMPORTANT!
NEVER lift the unit by the LNB assembly, Wave Guide assembly, or the dish.
Lift the unit ONLY by the base.