Kenwood KDC-MP345U - Manual (Page 15)

English | 15
Basic Operations of Remote Control
ATT
0 — 9
SRC
VOL
FM+ AM–
EXIT
/O
AUD
ENT
DIRECT
General control
Volume control: [VOL]
Source select: [SRC]
Volume reduce: [ATT]
When the button is pressed again, the volume returns
to the previous level.
Return to previous item: [ ]
Exit from mode: [EXIT]
Selection of item: [ 5]/[∞]
Determination: [ENT]
Enter Audio Control mode: [AUD]
In Tuner source
Band select: [FM+]/[AM–]
Station select: [ 4]/[¢]
Recall preset stations: [1] — [6]
In iPod/CD/Audio file source
Music select: [ 4]/[¢]
Folder select: [FM+]/[AM–]
Pause/Play: [ 38]
Movement between folders/files: [ 5]/[∞]
Return to previous folder: [ ]
Preparing the remote control unit
Pull the battery sheet out from the remote control
unit to the direction of the arrow.
Changing the battery of the remote control
unit
Use a commercially available button battery (CR2025).
Insert something narrow like a paperclip into the hole
1 and pull out the battery tray.
Insert the battery with the + and – poles aligned
properly, following the illustration inside the case.
Keep on slide
Pull out
CR2025(+side)
Not used.
(page 14)
¤
CAUTION
• Do not set the remote control in hot places such
as on the dashboard.
• Lithium battery.
Danger of explosion if the battery is incorrectly
replaced.
Replace only with the same or equivalent type.
• The battery pack or batteries shall not be
exposed to excessive heat such sunshine, fire or
the like.
• Keep battery out of reach of children and in
original package until ready to use. Dispose of
used batteries promptly. If swallowed contact
physician immediately.
B64-4529-00_00_en.indd 15 09.10.1 8:23:55 PM