Kenwood TK-190 User Manual
Page 3
Kenwood USA Corporation
July-07
MICROPHONE AND SPEAKERS CONT'D
KHS-15-BH
2
Hvy-duty noise reduction behind-the-headset w/noise cancelling boom mic & in-line PTT
(black); NRR24 db [Intrinsically Safe Approved Accessory] [SEE Note B]
400.00
KHS-15-OH
2
(black); NRR24 db [Intrinsically Safe Approved Accessory] [SEE Note B]
350.00
Note A: "Beige-colored" 2-wire & 3-wire mic models; Allow min. 4 weeks delivery time.
Note B: Heavy-duty headsets; Allow min. 4 weeks delivery time.
DIGITAL MODULE
CIM-1000
G-Star® or MDC1200 ANI Board : PTT ANI, emergency & man-down [Intrinsically Safe
Approved Accessory] - Factory Install Only –Order L-1038 or 1039.
125.00
CIM-CABLE
Serial Program Cable
59.00
CIM-1000 programs via Windows Hyper terminal (Windows Ver 3.1 or later) or any
ProComm version; board must be installed in a powered radio for programming. The
radio programmer does NOT program the CIM-1000. CIM-CABLE is a DB-9 PC
connector with 3 short lead with clips and may require a PC serial extension cable
KCT-56MS
Emergency Man-Down Internal Tilt Switch
[Intrinsically Safe]- Must be Kenwood installed for I.S.
Order L-1059 for install
21.00
KCT-56MS
FleetSync® Emergency Man-Down Internal Tilt Switch
[Intrinsically Safe]- Must be Kenwood installed for I.S.
Order L-1060 for install
21.00
SERVICE RELATED ACCESSORIES
KPG-36AM
Programming interface cable
N/A
KCT-53UM
USB Adapter for KPG-xxAM DB9F Programming Interface Cables (DB9M - to - USB
Type A connector);
81.67
KPG-59DK
Program Software for TK-190/6110 (Version 2.00)
N/A
*****************
Call Kenwood Parts at 800-367-7514 to order the following:
E30-3325-05
Portable-to-Portable Cloning cable (For TK-290/390/480/481 Only)
INSTALLATION / TUNING CHARGES
L-836
Assemble KMB-16 with six KSC-20's/24's
15.00
L-961
Assemble KMB-23 with six KSC-32K's (Rapid Rate, 120 Volt version only)
17.00
L-835
Configure TK-190/290/390 for Intrinsically Safe (Must Order KNB-17BK) - Note: Please
see end of this pricepages section for a list of Intrinsically Safe Accessories for this
radio.
70.00
L-979
Configure TK-190/290/390 (KNB-22NC) for Intrinsically Safe (Must Order KNB-22NC)
70.00
L-837
Install KNB-17A/17BK battery
0.00
L-870
Simultaneous transpond and alert feature up-grade for 90-series mobiles & portables
50.00
L-1038
TK-190/290/390 CIM-1000/MDC1200 ENCODER INSTALLATION
75.00
L-1039
TK-190/290/390 CIM-1000/GE STAR ENCODER INSTALLATION
75.00
L-1059
Install KCT-56MS (w/ CIM-1000K)
9.00
L-1060
Install KCT-56MS (for FleetSync®)
9.00
L-911
TK-190/TK-6110 Programming (with basic TX/RX check)
25.00
L-914
Cut KRA-21 Low Band Antenna
10.00
Page 3 of 4