Kenwood KTC-HR100 - Manual (Page 6)

— 6 —
English
When you are listening to the HD Radio, you can switch over the
display information as follows.
For operations, see the page of the
instruction manual of your control unit.
What is displayed may partly depend on control units to be
connected.
HD Radio mode
Information Display
Station Name "Station Name"/"NAME"
Song title/Artist name/Album name/Genre "Title"/"TITLE"
Receive Frequency "Frequency"/
Switching Display
Setting the displayed text scroll.
For operations, see the page of the instruction
manual of your control unit.
Text Scroll
Calling up the stations in the memory.
1 Select the band
Press the [FM] or [AM] button.
2 Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "[1]" — "[6]" are displayed above
the [1] — [6] buttons. (KDC-X969/KDC-X869/KDC-MP922)
Repeatedly press the button until the function item is not
displayed above the [2] — [5] button. (KDC-MP822/KDC-
V7022/KDC-X769/KDC-722)
3 Call up the station
Press the desired [1] — [6] button.
When the preset broadcast station is transmitting either an analog
broadcast or a digital broadcast, the sound will not be output unless
the broadcast mode matches the setting of .
Preset Tuning
Operations
• Displayed information except "Frequency" are shown only when
you receive text in digital broadcasting. If text cannot be displayed,
frequency will be shown.
• Though some models have two lines in the display, you cannot
display the same information in both the Upper Part and the
Lower Part.
[FM]/ [AM] buttons
Select the band.
Each time the [FM] button is pressed it switches between the
HF1, HF2, and HF3 bands.
Press the [AM] button to select the HA band.
[ 4]/ [¢] buttons
Tune up or down band.
[0] — [9] buttons
Press buttons [1] — [6] to recall preset stations.
In HD Radio source (Function of remote)